I think you need to convert your dat file to an expressions file. Then inset curve and choose point location by expression, point it to the expressions file and hit enter...
Best regards,
Michaël.
NX8.5.3 + TC Unified 8.3
Win 7 64 bit
The link is not working, but out of my head, you need to go to Edit - Options... - in the left column you will find NX then check the "Open in NX YES' check button. Apply or OK.
Could solve you're problem.
Best regards,
Michaël.
NX8.5.3 + TC Unified 8.3
Win 7 64 bit
Q1) press c
Q2) adapt your template part in sketch uncheck the snap arc centre option , save
Best regards,
Michaël.
NX8.5.3 + TC Unified 8.3
Win 7 64 bit
Thank you for the answer Cowski.
All the assemblies and all our users. Strange thing is when opening the subassy with file open command, all components are loaded and visible. Once you have saved the subassy or preform a revision increase, the make displayed part will show all components.
We did...
You'll need to create an account. Do this with your Webkey Access Code , found in the logfile. Then log an issue, provide them with all necessary info like, logfile of the session, a description of the problem, your system info, etc...
Best regards,
Michaël.
NX8.5.3 + TC Unified 8.3
Win 7 64 bit
Hello,
recently switched to nx8.5 from nx7.5. I'm searching for the setting in the 'Make displayed part' function, on how to make components visible (automatically)in the new view. So assy is loaded and all components are visible, in the part navigator I select a subassy and choose 'Make...
Is this part related? Which actions were performed? Maybe you could provide us with a part of the log file?
Best regards,
Michaël.
NX8.5.3 + TC Unified 8.3
Win 7 64 bit
First change the setting 'From Pattern Feature' to 'Circular'. Then in the next screen, Axis Definition --> Datum Axis, choose the Z axis, Total number = 6 and Angle = 60. Ok , done.
Best regards,
Michaël.
NX8.5.3 + TC Unified 8.3
Win 7 64 bit...
"Watch" out we've got a student over here. Was my first response yesterday but didn't post it, should have don it, especially with John's clock manufacturing response... [bigglasses]
Best regards,
Michaël.
NX8.5.3 + TC Unified 8.3
Win 7 64 bit
I just downloaded the MP8 pack for NX8.5 and the problem still occurred. But some progress has been made, after the first time the error popped up, I was able to open the part file in the second attempt. So I asked our system admin to do a refile for all the files in TC. My guess is that the...
Hello, after upgrading the from NX7.5 to NX8.5.3 we got some error messages when loading older files. I searched the interwebs for a solution and only found one hit from this forum,
http://www.eng-tips.com/viewthread.cfm?qid=314011 this contains an IR number, so I went to the GTAC site and...
