Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

smcadman
  • Locked
  • Question
Offset Section View jog lines
Replies
3
Views
106
Heckler
Heckler
castermaster
  • Locked
  • Question
Does a centerline datum follow a deflected shape?
Replies
4
Views
124
caseynick
caseynick
scotty7
  • Locked
  • Question
What Drafting Standards do International Companies Use?
Replies
10
Views
525
castermaster
castermaster
KimBellingrath
  • Locked
  • Question
countersink callout 1
Replies
16
Views
971
ewh
ewh
debodine
  • Locked
  • Question
Drawing Requirements Manual
Replies
6
Views
295
Tunalover
Tunalover
Runz
  • Locked
  • Question
How does Rule #1 apply to 2 holes... 1
Replies
12
Views
264
ewh
ewh
ant77
  • Locked
  • Question
E-clips on centered shaft
Replies
11
Views
209
ant77
ant77
Runz
  • Locked
  • Question
Angular (Timing) orientation of 2 different patterns?
Replies
9
Views
195
drawoh
drawoh
chevy1000
  • Locked
  • Question
Dimensioning a surface from 4 inline holes. 1
Replies
2
Views
119
ewh
ewh
spacemonkey3D
  • Locked
  • Question
Drawing Requirments Manual?
Replies
3
Views
82
debodine
debodine
terbo29
  • Locked
  • Question
Location information for Hole Position Relative to Basics
Replies
5
Views
125
drawoh
drawoh
zora65
  • Locked
  • Question
Blended Radius
Replies
2
Views
424
ctopher
ctopher
Runz
  • Locked
  • Question
Datum call-out on tangency of two radii...
Replies
2
Views
101
AliThePro
AliThePro
whotmewory
  • Locked
  • Question
GD&T for controlling excessive "twist." 1
Replies
15
Views
480
dingy2
dingy2
thundair
  • Locked
  • Question
ANSI Y14.5 6
Replies
8
Views
178
thundair
thundair
Tunalover
  • Locked
  • Question
Where are the machine shops that REALLY know GD&T?
Replies
4
Views
121
Heckler
Heckler
ye368
  • Locked
  • Question
datum target areas
Replies
3
Views
417
dingy2
dingy2
Pevac
  • Locked
  • Question
Attaching Geometric Tolerance frame to a surface? 2
Replies
15
Views
259
dingy2
dingy2
CorBlimeyLimey
  • Locked
  • Question
Section Line With Single Arrow
Replies
4
Views
253
Heckler
Heckler
ewh
  • Locked
  • Question
surface finish acronym
Replies
1
Views
93
ctopher
ctopher
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top Bottom