Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Drafting Standards, GD&T & Tolerance Analysis

FrenchCAD
  • Locked
  • Helpful tip
ASME Y14.5M-1994 interactive trainer 1
Replies
3
Views
79
BiPolarMoment
BiPolarMoment
zissou
  • Locked
  • Question
Several easy (...hopefully...) questions.
Replies
8
Views
133
ctopher
ctopher
ewh
  • Locked
  • Question
"Simultaneous Requirement"? 2
Replies
8
Views
256
dingy2
dingy2
Tmoose
  • Locked
  • Question
drawing rev varies, sheet by sheet
Replies
19
Views
504
ctopher
ctopher
BAR1969
  • Locked
  • Question
Standard for numbering notes
Replies
1
Views
61
ctopher
ctopher
Starchief
  • Locked
  • Question
Torque callouts
2
Replies
27
Views
3K
ctopher
ctopher
GunT
  • Locked
  • Question
Depth of a CB hole on a incline 2
2
Replies
34
Views
816
aardvarkdw
aardvarkdw
RyanCR
  • Locked
  • Question
Broken Dia and callout?
2
Replies
20
Views
464
aardvarkdw
aardvarkdw
pittgrad
  • Locked
  • Question
standard drafting symbols or hatches 1
Replies
2
Views
97
dbaird
dbaird
wuqn
  • Locked
  • Question
standard in zone 2
Replies
1
Views
69
ctopher
ctopher
Uka
  • Locked
  • Question
Axis Control
Replies
1
Views
97
dingy2
dingy2
JMarks
  • Locked
  • Question
specifying alignment between two parts on drawing
Replies
3
Views
523
dingy2
dingy2
ye368
  • Locked
  • Question
Can one feature be used for both secondary and tertiary datum? 2
Replies
10
Views
183
drawoh
drawoh
ye368
  • Locked
  • Question
Can a feature be controlled by two different position callouts?
Replies
1
Views
93
drawoh
drawoh
AliThePro
  • Locked
  • Question
Quiz on straightness of line elements
Replies
6
Views
199
jmwalden
jmwalden
RubenGman
  • Locked
  • Question
Who's responsible for understanding GD&T besides the drafter/designer?
2
Replies
36
Views
566
ctopher
ctopher
Martingineer
  • Locked
  • Question
Max material on run out
Replies
2
Views
312
dingy2
dingy2
geoffthehammer
  • Locked
  • Question
Tolerancing problem
Replies
4
Views
149
AliThePro
AliThePro
cadfreak
  • Locked
  • Question
General notes for a Socket Set Screw Dog Point?
Replies
3
Views
114
CoryPad
CoryPad
cadfreak
  • Locked
  • Question
Drafting Standards Quick Reference...
Replies
2
Views
88
Heckler
Heckler
You must log in or register to post here.

Part and Inventory Search

Sponsor

Back
Top Bottom