Jul 22, 2011 #1 DaiG Mechanical Jul 12, 2011 8 Hi. Does anybody know how to find the diameter of a Vena Contracta in orifice plates in gas/vapour flows?
Hi. Does anybody know how to find the diameter of a Vena Contracta in orifice plates in gas/vapour flows?
Jul 22, 2011 Thread starter #3 DaiG Mechanical Jul 12, 2011 8 A vena contracta is point in flow where a jet of fluid is narrowest. It's not 'governed' by any measurable boundry. Was after an analytical solution. Upvote 0 Downvote
A vena contracta is point in flow where a jet of fluid is narrowest. It's not 'governed' by any measurable boundry. Was after an analytical solution.
Jul 22, 2011 #4 zdas04 Mechanical Jun 25, 2002 10,274 Pretty good explaination at Princeton Paper David Upvote 0 Downvote
