Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

TIE REINFORCEMENT BETWEEN RC FRAME COLUMNS AND BRICK WALLS

Status
Not open for further replies.

tmgczb

Structural
May 12, 2021
174
Happy Chinese New Year!
Snap55557_iuhkbf.png
Here,brick walls are partition walls.
I just want to know if there is some requirement in codes or standards which restraints the spacing of horizontal reinforcement.
 
Replies continue below

Recommended for you

Depends on what code you are using. In the US, there is no code requirement that brick walls must be tied to RC frame columns.
 
MotorCity said:
Depends on what code you are using. In the US, there is no code requirement that brick walls must be tied to RC frame columns.
What about this provision in ACI-530?
Snap55558_uegpqq.png
 
...often use dovetail slots in the concrete to provide vertical adjustment.

-----*****-----
So strange to see the singularity approaching while the entire planet is rapidly turning into a hellscape. -John Coates

-Dik
 
dik said:
...often use dovetail slots in the concrete to provide vertical adjustment.
Better share some details.
 
tmgczb said:
What about this provision in ACI-530?

As written above, that is for intersecting walls that depend on each other for lateral support.
 
derim01 said:
As written above, that is for intersecting walls that depend on each other for lateral support.
Yes, but are there any applicable provisions in American code or British code?
Snap55559_efqvka.png
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor