Tap into a blind hole

[nornrich]

All,

Is there an option on the hole wizard to drill and tap for machined flat bottomed hole?

Rich.....

Richard Nornhold, PE

http://www.ovenind.com

 

[fcsuper]

Legacy hole

Matt Lorono
CAD Engineer/ECN Analyst
Silicon Valley, CA
Lorono's SolidWorks Resources
Co-moderator of Solidworks Yahoo! Group
and Mechnical.Engineering Yahoo! Group

 

[CorBlimeyLimey]

Use the Show custom sizing option in the Hole Specifications section to change the drill angle to 180°.

The drilling and tapping depths can be controlled in the End Condition section.

 

[RawheadRex]

Ditto to CBL's suggestion.

Best regards,



Chris Gervais
Application Engineer
CSWP, CSWST

 

[Gupta65]

Do as CBL suggested and if you need it over and over, add it to hole favorites.

Deepak Gupta
SW2009 SP3.0
SW2007 SP5.0
MathCAD 14.0