ulloap
Mechanical
- Jul 5, 2007
- 22
Hi,
I'm running axisymetric contact analysis, 3 deformable parts, one of them hyperelastic, but right now i wanna transfer the results into another 3d new analyis to apply non axisymetric loads.
I know that abaqus manual says, thats no possible to transfer results from assembly instances. BTW, what's the trick when we're facing troubles like this.
The error im getting from is:
***ERROR: Node 1169 does not belong to instance 'BELL-1' and cannot be
assigned to instance node set 'ASSEMBLY_SPIGOT-1_SPIGOT-REFPT_'
***NOTE: DUE TO AN INPUT ERROR THE ANALYSIS PRE-PROCESSOR HAS BEEN UNABLE TO
INTERPRET SOME DATA. SUBSEQUENT ERRORS MAY BE CAUSED BY THIS OMISSION
Regards
I'm running axisymetric contact analysis, 3 deformable parts, one of them hyperelastic, but right now i wanna transfer the results into another 3d new analyis to apply non axisymetric loads.
I know that abaqus manual says, thats no possible to transfer results from assembly instances. BTW, what's the trick when we're facing troubles like this.
The error im getting from is:
***ERROR: Node 1169 does not belong to instance 'BELL-1' and cannot be
assigned to instance node set 'ASSEMBLY_SPIGOT-1_SPIGOT-REFPT_'
***NOTE: DUE TO AN INPUT ERROR THE ANALYSIS PRE-PROCESSOR HAS BEEN UNABLE TO
INTERPRET SOME DATA. SUBSEQUENT ERRORS MAY BE CAUSED BY THIS OMISSION
Regards
