Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Surface Contact NX 7.5

Thread starter prakhar5aug
Start date Aug 10, 2014

Status: Not open for further replies.

Aug 10, 2014

prakhar5aug

Automotive

i have modelled two sheets which are welded together by spot weld my problem is when i apply load the sheets passes through each other which should not be the case and when i use mesh mating condition the surface move together but there is no stress on spot weld.....so help in choosing the right constrain so that sheets do not pass through each other and are pulled by spot weld only...