STEPPER MOTOR

After refer to the web page on stepper motor. I found out the motor able to be controlled by using the pc parrel port but I clearly dont know how to use the port more wisely for this pupose. If any one knows about this pls share with me.

 

[jbartos]

Suggestions:
1. The stepper motor may need its controller and software. These usually come from the manufacturer.
2. Please, provide more info about your stepper motor, e.g. nameplate data.
3. Visit

http://www.eio.com/stepindx.htm

http://www.doc.ic.ac.uk/~ih/doc/stepper/

http://www.cs.uiowa.edu/~jones/step/index.html

http://www.motiongroup.com/

etc.
for more info

 

you can get the address of the parallel port at 0000:0408
using any programming language and send data to that address