Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

steel design

Thread starter IYIeI2cY
Start date Jul 3, 2003

Status: Not open for further replies.

Jul 3, 2003

IYIeI2cY

Structural

im trying to design a steel truss using autoselect sections in Sap2000 V.8, the design sections differ from the analysis sections, i know that i must re-analysis untill i got the design section the same as the analysis sections, i tried to re-analysis many times, i tried "make autoselect section null", i tried almost every thing i know but the design was funny,
any one know the right procedure to do that !!

Pea$e