Siemens 110 system

[tsection]

Hi guys,

Anyone know anything about the old Siemens 110 system? I have a counter unit to program for this rack and I am not sure how to communicate to the rack even?

If anyone still has any manuals or catalogues for this system I would be very grateful for some guidance

Cheers

Nick

 

[JesperMP]

I think that the S5-110U was programmed with a hardware programming unit, not with a PC (or PG as Siemens has it).
All the code was in a continous block (no subroutines).

Before you do ANY changes to the system, consider how much time and expense it will take to rip it out and replace it with a newer PLC.
The S5-110U is O-U-T. Any more fiddling with it is a potential nightmare.

 

[Skogsgurra]

Try to contact a Siemens office. If you are lucky, they will still have an S5 technician and an old PG available. But it will cost a lot of "Geld" and there will probably not be any guarantee that there will be a happy ending :-(

 

[tsection]

I have found that to speak to the rack I need a PG631, and I have one, hurra! but I am missing the cable, a 734 cable from a PG631 to a 500programmer interface card.

Siemens no longer have any details on this cable.

Would love to get hold of one if anyone can help?

And yes JesperMP this stuff is so old it is hardly worth fixing, but thats not for me to decied in this instance.

 

[JesperMP]

Go to Siemens technical forum and ask about the cable details there. There were a few S5-110 posts before. With a little luck there is someone with the cable that he can open up and get the wire/pin definitions.

http://www4.ad.siemens.de/WW/llisap...99&Forum=show&board=AutomationDrives&wbforum=

 

[tsection]

JesperMP,

Many thanks I had not hurd of this forum.

Nick