Richards Valves 1

[blueprint]

I have a spread sheet with the valves for a project listed.
It calls for a 300# ansi flanged 80dn ball valve, it then goes on to give the trim code as 080-SBBTST /00, I suspect that this code is not righ, to analise the trim code you need "Richards Selection Guide PIM-AA-05", I cant find this document anywhere on the web.
Here is the valve in question, any help appreciated.

http://www.tycoflowcontrol-pc.com/ld/R721_R723_12_03.pdf

Cheers.

 

[pennpiper]

Call the vendor.
The contact information is on

http://www.tycoflowcontrol-na.com/

 

[stanier]

Rishards ball valves were maufactured in Brisbane Australia. Tyco bought them out.

They manufactured floating ball reduced and full bore valves complying with BS 535I.

http://www.tycovalves-pc.com/products_results.asp?Selection=Ball+Valves&m=1