Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Postprocessing Reactions

Status
Not open for further replies.
Bagman2524

Bagman2524

Structural
Jul 14, 2005
707
Does anyone know how to edit reaction information in the postprocessign mode of STAAD? I want to only show vertical or horizontal reactions and remove the moments.
Thanks
 
Replies continue below

Recommended for you

Sort by date Sort by votes
In the post-processor, select all of the nodes, select "Support Reactions" in the reports menu. When the reactions are displayed, click on the upper left corner block labeled "Node". This selects the entire table. Now press Ctrl-C to copy it to the clipboard. Open Excel and paste it into a blank spreadsheet. Everything will be copied into separate columns. Now you can delete the columns that you don't want.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

kk88818
  • Locked
  • Question
Is it possible to assign Postprocessing values to Modeling mode? 1
Replies
5
Views
162
RAYC1
RAYC1

Part and Inventory Search

Sponsor

Back
Top Bottom