Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Plastic Handle Installation

Status
Not open for further replies.
crutch

crutch

Civil/Environmental
Oct 3, 2002
1
We injection mold round containers ranging in size from 1 to 5 gallons. I would like to know if anybody has seen any atuomation equipment that will install plastic handles either in the mold after opening or as a secondary operation?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Why not design the container with an integral handle? I Can help with this...
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

MechMatengineer
  • Question
Quality control for plastic piping
Replies
1
Views
3K
Pud
Pud
Thanh_fromVietnam
  • Locked
  • Question
Best plastic material/ grade for Plastic Pallet 1
Replies
2
Views
991
dgallup
dgallup
Snowshovel1
  • Locked
  • Question
Best plastic material /grade for snow shovels
Replies
4
Views
2K
IRstuff
IRstuff
Azeen
  • Locked
  • Question
Mixing virgin and recycled Polypropylene Granules in single use plastic straw extrusion machine
Replies
5
Views
882
Linda0510
Linda0510
clyde Verse
  • Locked
  • Question
Any way to produce a 100% same plastic lampshell without injection mold?
Replies
5
Views
1K
Pud
Pud

Part and Inventory Search

Sponsor

Back
Top Bottom