Rob_N
Automotive
- Nov 17, 2009
- 275
I'm attempting to "morph" the surfaces using these sections but it seems I can only select one section curve as a control. I'm hoping I don't have to split it up into multiple patches.
The ends constrained nicely, but just selecting the center most section curve isn't enough.
any suggestions? Theres quite a bit of info on Youtube as to how to do this with various softwares. in those you can pick multiple sections to drive the change.
The ends constrained nicely, but just selecting the center most section curve isn't enough.
any suggestions? Theres quite a bit of info on Youtube as to how to do this with various softwares. in those you can pick multiple sections to drive the change.
