Jun 1, 2005 #1 SteveVan Mechanical Dec 10, 2002 16 I'm using Wildfire 2.0. Is there an easy way to switch a feature to a layer and remove that same feature from all other layers, all in one command.
I'm using Wildfire 2.0. Is there an easy way to switch a feature to a layer and remove that same feature from all other layers, all in one command.
Jun 1, 2005 #2 Hora New member Apr 23, 2002 585 Did you try to create a mapkey? -Hora Upvote 0 Downvote
Jun 13, 2005 #3 JB36 Industrial Jun 13, 2005 2 Hello, Modelcheck can do the job automaticaly. It is a bit hard to configure, but then you can batch the job over all your models easily. Upvote 0 Downvote
Hello, Modelcheck can do the job automaticaly. It is a bit hard to configure, but then you can batch the job over all your models easily.
Jun 15, 2005 Thread starter #4 SteveVan Mechanical Dec 10, 2002 16 JB36 Modelcheck sounds like a good idea i'll give it a try thanks Upvote 0 Downvote
Jul 11, 2005 #5 cutlass442 Mechanical Jul 8, 2005 2 SteveVan, Were you ever able to accomplish this using Model Check? If so can you give me some details. thanks Upvote 0 Downvote
SteveVan, Were you ever able to accomplish this using Model Check? If so can you give me some details. thanks
