Full round blend 1

[Bhaveshn]

Does anybody know How I can gice full round blend between 3 faces?

 

[Bhaveshn]

Does anybody have solution?

 

[donyoung]

Hi,

this way?

Corner_rnd V19

All 3 edges selected and then the radius is applied

dy

 

[Bhaveshn]

No, not edges, I want full round between three *faces*

 

[donyoung]

the outcome will be the same, I think. It will work
with 3 faces as well. There are, however, 2 steps more
for you can only select 2 faces.

dy

 

[donyoung]

Hi,

the number of steps is only one more (it was due to my selection)

[Link

Http://files.incobase.de/Frnd_blnd_V18.zip

]Blend/Radius (V18)[/url]

dy

 

[Bhaveshn]

It doesn't work. May be, I don't get your point.

 

[donyoung]

Hi,

it *may* not work on your model because of the faces you
try to blend. In my example they are straight and plain ;-)

dy

 

[beachcomber]

I think what Bhaveshn is trying to achieve is this :
Imagine a trangular stiffening web on a casting. If the web then has a draft angle applied to the side faces the top face will vary in width. What you now need to do is completely remove the flat top face by applying a varying radius fillet that is tangential to both side faces and the top face - as the pattern maker may do with his sand paper.
As far as I know this is not possible with the fillet command - unless it's been added as an option in V19 (or V20?).
It is something that is in Catia and also, I think, Solid Works.
Try using a variable radius fillet and adjusting the radii.
I just tried creating a blue surf and using the replace face command but couldn't get it to work.

bc

 

[Bhaveshn]

Hi bc,
Thanks.
I think, this is a good reply to clear my doubts, but not complete solution for we both, right?

 

[donyoung]

so as usual: the initial question accompanied by a
picture would have been an advantage -- no guessing
needed ;-)

dy

 

[beachcomber]

Bhaveshn,
You could try building the feature as surfaces, then uniting them with your solid body.
perhaps someone should submit an enhancement request.

bc

 

[Bhaveshn]

Yes Don, It might be a godd idea to attach picture, I learned, thanx

 

[Bhaveshn]

Hi Don
How I can attach picture to postings?

 

[fwc]

Check this FAQ

http://www.eng-tips.com/faqs.cfm?fid=1100