Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Eccentricity

Status
Not open for further replies.
piping1971

piping1971

Mechanical
Jun 28, 2002
10
What is GT STRUDL recommendation for modeling a joint from
Tubesteel center to it outer surface.Would be just another
tubesteel or a ridid element which you cam model by specifiying eccentricity.From piping it is usually recommended to model the node from center of pipe to its
outer surface as rigid.Is it the same for GTSTRUDL.


Your recommendation is highly appreciated.

Thanks,
Ellie
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top Bottom