Deflection Check with DFF parameter

[Akiram85]

Hi everyone!

Im doing a calculation for a small steel structure supporting equipment.
At the end I would like to check deflections for all the beams for serviceability load combination.

I used DFF parameter..defined DJ1 and DJ2 where necessary but when I print results from Print-Report-Output-Steel Detail Design
this message is shown : "No deflection check have been done".

Can anybody help me?

Thanks a lot!!!

 

[SethGuthrie]

Here are a couple of posts from the Bentley Communities site that might help:

https://communities.bentley.com/products/structural/structural_analysis___design/f/5932/t/63965.aspx

https://communities.bentley.com/products/structural/structural_analysis___design/f/5932/t/87607.aspx

 

[Akiram85]

Thanks for your posts...
I had already read them...but I didn't solve my problem....

I put Deflection Check but it doesn't check...I really don't know...