jszymkowski
Automotive
- Dec 27, 2002
- 14
What is the best way to control the size of a radius within the boundaries of a profile?
In the attached sketch, the nominal line in blue is flanked by the min and max profile boundaries. An undesirable condition is shown in pink. What controls are best utilized to ensure that the corner radius of the measured part does not exceed the min/max radius of the profile limits? Specifying a locational tolerance for the center of the radius seems logical, but presents it's own limitations when measuring a semi-circle less than 180°
I can't seem to attach the file, so here's a direct link:
In the attached sketch, the nominal line in blue is flanked by the min and max profile boundaries. An undesirable condition is shown in pink. What controls are best utilized to ensure that the corner radius of the measured part does not exceed the min/max radius of the profile limits? Specifying a locational tolerance for the center of the radius seems logical, but presents it's own limitations when measuring a semi-circle less than 180°
I can't seem to attach the file, so here's a direct link: