Jun 23, 2009 #1 QAOne Aerospace Jun 23, 2009 6 I am checking a .003" circular runout with a .0005" dial indicator. Is this sufficient measurement resolution? Or, is .0001" preferred?
I am checking a .003" circular runout with a .0005" dial indicator. Is this sufficient measurement resolution? Or, is .0001" preferred?
Jun 23, 2009 1 #2 HGMorgan Aerospace Aug 27, 2007 120 General rule of thumb is 10 to 1, I.E.: if tolerance is .01, need to check with instrument capable of .001 or less. You have .003, 10 to 1 would be .0003, so, go with the .0001 Upvote 0 Downvote
General rule of thumb is 10 to 1, I.E.: if tolerance is .01, need to check with instrument capable of .001 or less. You have .003, 10 to 1 would be .0003, so, go with the .0001
Jun 23, 2009 Thread starter #3 QAOne Aerospace Jun 23, 2009 6 Thanks. Also, do you have any guidance on gage error in this application? Is there a rule of thumb? Upvote 0 Downvote
