Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Circular Repeat to make cog

Thread starter ILEN
Start date Dec 16, 2006

Status: Not open for further replies.

Dec 16, 2006

ILEN

Aerospace

I've been using the circular repeat function to design a cog. I create one tooth in 2d sketch, repeat that, then join all of the teeth using the coincident constraint. Depending on the amount of teeth, this could take a while. The finished product ends up being off center. Is there a more efficient way to do this?