Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Calculation Module

Thread starter Sparkette
Start date Jun 7, 2005

Status: Not open for further replies.

Jun 7, 2005

Sparkette

Electrical

Has anyone else been using the Calculation Module? In using the module for control valve sizing I have found that when calculating values for low flow conditions (around 1000 gpm) the Cv that I get seems to be erroneous.

I used a second program called QuickSize from Dresser and the value calculated was what I expected to see so that led me to believe that the calc module for INtools has an inherent error in it.

Anyone else? [sadeyes]