Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Calculation minimum Z Retract

Thread starter Chigishev
Start date Nov 6, 2015

Status: Not open for further replies.

Nov 6, 2015

Chigishev

Computer

One interesting project. 5-Axis CNC, after each operation 3+2 moving to ZMAX, then down, and repeat it each time. I add DLL, linked to postprocessor, and calculate minimum Z_retract. One note - this CNC machine havenot TRAORI, CYCLE800 only. In this case I make 100 intermediate position for Z min calc..