I am not an electrical engineer but I took a few circuit classes in college 20 years ago 😂. Before I burn up some very expensive LED’s can someone please check my work?
Here is the situation: I have a 36V/63Ah LifFePo deep cycle marine battery that I need to connect to four 12V/10A LED’s on my...
Friends,
My company developed a clamp that fits around a vertical pipe to allow a connection to wind brace member (acts in tension and compression) that comes in at an angle. This clamp uses a single thru-bolt to close the clamp and secure the wind brace to the clamp/vertical pipe.
We had this...
Friends,
I work for a firm that designs canopies and solar structures and we exclusively use ASCE 7 to design them as monoslope free roofs (Fig 6-18A in 7-05 and 27-4-4 in 7-10) . This works great for tilt angles ranging from 0 to 45 degrees, but I have a client that wants us to design a solar...
The parts are in the design process so I don't know if they would loosen up and I don't have any pictures. I am looking to see if I get a warning like "holy cow that is the dumbest thing I've ever heard of! don't do it!
Friends,
I am looking at designing a grade 5 3/8" bolt assembly that needs a 1"x7/16" slot for horizontal adjustability (force will be in tension, perpendicular to the slot). I prefer the bolt to be secured with a standard serrated flange hex nut, but I am wondering if the limited amount of...
Thanks for the response. I am just wondering about the flattened end, which will also be punched with a slot/hole for a bolted connection, designed to not be scary per AISC.
This is a part for a solar application that will have minimal risk to life. Attached is a drawing of the part...
I am looking at flattening the end of a tube for an easier mechanical connection, but I want to make sure the resulting shape is strong enough to handle the applied design loads. I can make the part in Autodesk Inventor and run it through the program's FEA application, but with my limited...
Rconner: I had previously found that circular but it was the wrong one, it deals with magnetism. I did some research on google scholar and found it located here:
http://babel.hathitrust.org/cgi/pt?id=mdp.39015077295122
This thread can be closed and archived since I have answered my own...
I found this thread:
http://www.eng-tips.com/viewthread.cfm?qid=191227#post
and I am looking for this reference:
M. Romanoff, Underground Corrosion, National Bureau of Standards Circular 579, 1957
Any ideas on where I can find it? I am looking to obtain corrosion rates of galvanized steel...
BA - yes, I am trying to reduce the member.
JS - higher strength steel is a option.
Just to give an idea, each structure is about 30' long by 15' wide, monosloped open to the air. The beam in question is a 4" round tube that I would like to reduce the wall thickness of in order to reduce the...
Thanks for all your input! I suppose I will not move forward with that design modification.
I actually work for a company that does little structures like this all the time and they are also pressuring to lighten the system as well (in this case the client is pushing harder than my company)...
I am using ASCE 7-10 for wind and snow loading, etc and it is true that that there are reductions in the loads due to risk/importance. There are no building codes governing this installation and the client is looking to reduce the steel and this is one way I can see a possibility.
It is the...
