My company plan to set up a sub-zero process capability and get the Nadcap certificate. I know the equipment should follow the AMS2750D, it means TUS ans SAT must be meet. but I have no idea about the detail equipment specification of the freezer. Most of my friends just have the experience in...
VE1BLL,
Yes, we have the dispute now. the actual measurement is 7.03 X 10 -3 Torr, supplier insist this meet the specification. He said the "1 X 10 -3 Torr Range" means "1 to 9.9 X 10 -3 Torr" is the contract specification range.
I thought that " the best vacuum is 1 X 10 -3 Torr Range" can be...
The best vacuum level I need is 1 X 10 -3 Torr.
But I jsut found that I made a mistake, it was written as " 1 X 10 -3 Torr Range" in the contract.
Will someone heip to let me know what the difference in between?
Does the supplier still have to meet the best vacuum level?
if yes, where I can...
please help to provide some information below.
what is the difference between the Fixed thread ring gage and the adjustable ring gage?
How do I know which one will be the best to be used/purchased?
Is the calibration method can be a problem?
Thank you.
The wheel dressing has been tried to every 8 pieces. I guessed the wrong wheel was selected, not relate to wheel dressing.
I used the 93A60J8V7N grind wheel today, the result is not good, and the roughness is 0.6.
Yes, I would like to rough in and finish grind in the same operation cycle. Does...
Grinding problem – can’t meet Roughness 0.2 micro mm
I had a problem in grinding operation. Is anybody can help me to provide your comment?
Material: AMS 5659 (H1025) Corrosion Resistant Steel
Dimension: (in mm)
Before grinding: 11.40 Dia X 8.20 Dia
Specification requirement:
11.20 Dia...
is there anyone can give me the definition or explaination about the terms below:
Shell Press
multi die
multi die tooling
die shoe
conversion press system
RPT
SOT
thank you.
Is somebody can help me to confirm the following:
A UNJF Ring Gauge can be used to inspect the component's UNF External Thread.
A UNJF Plug Gauge can not be used to inspect the component's UNF Internal Thread.
Thank you.
For Grinding, Lapping, Honing, Polishing and burnishing, they all make a good surface finish and just remove very little amount of material. Will somebody can help me to provide their exact definitions and the differences in between.
Thank you for your help.
As I know, the term of Deep Hole Manufacturing is according to the ratio of the Diameter and the length of the hole to be manufactured. If the actual ratio value is smaller, then it can be named as Deep Hole manufacturing but a common machining or drilling.
I can’t remember this ration value...
I am new in calibration. A customer asked me what ANSI standard do you use to calibrate the caliper, micrometer, depth gage, etc., I can't find the answer from the internet. What I do is according to the supplier’s spec. or catalog.
Is anyone can help me? Tell me the ANSI Spec. # for different...
Thank you for your suggestion,Powerhound.
I don't know what it will be used for. The customer didn't provide the answer and I can not answer your question due to the NDA.
Could you give me some more suggestions about this issue?
Allenchu
A Drive Shaft is going to be measured, but there are some considerations that I don’t have the answers yet and don’t know if the measuring method I planed is correct or not. Please help me to provide the answers or your suggestions.
Drive Shaft Description:
Overall Length: 380 mm
Diameter A...
