Dec 10, 2011 #1 corey796 Industrial Dec 6, 2011 7 Ok i cant move the circle but it shows as not being fully defend i cant add any relation's they over define the sketch so what do i do thanks
Ok i cant move the circle but it shows as not being fully defend i cant add any relation's they over define the sketch so what do i do thanks
Dec 10, 2011 1 #2 CorBlimeyLimey Mechanical Nov 5, 2003 15,292 Select the circle and the Top Plane and add a parallel constraint. Upvote 0 Downvote
Dec 10, 2011 #3 CorBlimeyLimey Mechanical Nov 5, 2003 15,292 Even though the circle was drawn while being parallel to the Top Plane (or in the X-Z mode), the constraint isn't automatically added. I don't know if that is intended or a bug. Upvote 0 Downvote
Even though the circle was drawn while being parallel to the Top Plane (or in the X-Z mode), the constraint isn't automatically added. I don't know if that is intended or a bug.
Dec 12, 2011 #4 TILngr Mechanical Sep 24, 2011 3 Not defined because it's in a 3d sketch. If it were based on a plane it would have been fully defined at that point (coincident center and radius). Upvote 0 Downvote
Not defined because it's in a 3d sketch. If it were based on a plane it would have been fully defined at that point (coincident center and radius).
