Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

What is the proper thread undercut value before plating?

Status
Not open for further replies.
kpenn

kpenn

Mechanical
May 15, 2001
1
I have an M3 screw that is going to get plated with a total buildup of .00015-.00025" (.004-006mm)of silver plating. What would be the proper undercut value for this M3 thread screw and how is this value determined?

Any help would be very much appreciated.
Thanks
 
Status
Not open for further replies.

Similar threads

rollingcloud
  • Locked
  • Question
What is the most likely reason for the wear on the bolt's thread? 3
Replies
10
Views
566
mfgenggear
mfgenggear
FrancoisY
  • Question
What is this Material & Specification? Please help 3
Replies
4
Views
5K
FrancoisY
FrancoisY
EngTipsAccount1234
  • Question
Does a bolt in a threaded hole have a preload or clamping force? If not, what is keeping the joint together.
Replies
7
Views
3K
mfgenggear
mfgenggear
rollingcloud
  • Locked
  • Question
What would be the most likely cause of nut thread stripping? 3
2
Replies
22
Views
998
mfgenggear
mfgenggear
L
  • Question
Left vs right thread 1
2
Replies
23
Views
5K
mfgenggear
mfgenggear

Part and Inventory Search

Sponsor

Back
Top Bottom