Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

what is the exact dimension of the 1/4" NPT thread acc to USAS B2.1?

Status
Not open for further replies.
Thyagaraj A H

Thyagaraj A H

Mechanical
Nov 12, 2019
6
what is the exact dimension of the 1/4" NPT thread acc to USAS B2.1?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
With USAS B2.1 I assume you mean ANSI B2.1, which is superseded by ANSI B1.20.1, which at its turn was superseded by ASME B1.20.1. Do you own a copy of B1.20.1? If so, have you looked in the code? If not, I suggest you purchase a copy, and look for the relevant section. This forum is not intended to do that work for you.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

rollingcloud
  • Question
Is my understand of the FRTZF correct?
Replies
7
Views
5K
rollingcloud
rollingcloud
MattEdwards
  • Locked
  • Question
Specifying the orientation of a dimension 1
Replies
19
Views
677
3DDave
3DDave
F
  • Question
Use the Drawing title block linear tolerance to control a Diametrical callout size - is it correct? 1
Replies
3
Views
2K
Burunduk
Burunduk
HR ShoveNstuff
  • Locked
  • Helpful tip
NPT Thread Depth
Replies
6
Views
1K
Wuzhee
Wuzhee
sendithard
  • Question
Is this image an error in the 2018 standard
Replies
5
Views
3K
Burunduk
Burunduk

Part and Inventory Search

Sponsor

Back
Top Bottom