Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

UDL over a 3rd of a inner diameter?

Status
Not open for further replies.
l354uge

l354uge

Automotive
Mar 1, 2017
1
Hi all,

I need to apply a UDL over a 120degrees of the inside face of a circle. I've managed to do 180 for another load case thanks to how the surfaces were imported, but dont know how to apply it to 120degrees?
 
Status
Not open for further replies.

Similar threads

Nir_k
  • Locked
  • Question
How to select both the exterior and interior surfaces (All Entities) of an element when creating surfaces in Hypermesh?
Replies
0
Views
2K
Nir_k
Nir_k
Sayed Ghalleby
  • Locked
  • Question
Modal analysis and effective mass fraction modification
Replies
1
Views
1K
GregLocock
GregLocock
mpvnaresh
  • Locked
  • Question
Hi.. I am working on a structura
Replies
0
Views
448
mpvnaresh
mpvnaresh
Beider
  • Locked
  • Question
Modeling HDPE with upper and lower yield points and >300% strain - RADIOSS
Replies
1
Views
572
hiper_88
hiper_88
mj345
  • Locked
  • Question
Altair Hyperview/Hypergraph- ratio of ALLSD to ALLIE
Replies
0
Views
126
mj345
mj345

Part and Inventory Search

Sponsor

Back
Top Bottom