Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

torsion+bending

Status
Not open for further replies.
jiao

jiao

Structural
Dec 1, 2001
30
Is there any way I can calculate the shear+bending deformation together when a lateral force is not acting on the shear centre of the section (there should be torsion automatically)? assumng the default point of load is at centre of gravity.

Thanks
 
Status
Not open for further replies.

Similar threads

steelnz2003
  • Locked
  • Question
U channel under flange bending
Replies
0
Views
100
steelnz2003
steelnz2003
ThisMustBeAJoke
  • Locked
  • Question
Torsional Moment 1
Replies
1
Views
244
Trenno
Trenno
Jatfuentes
  • Locked
  • Question
Does SAP 2000 Design for Torsion ?
Replies
9
Views
1K
Shz713
Shz713
kww2008
  • Locked
  • Question
Hinge -pin for positive bending and rigid for negative bending
Replies
1
Views
86
kww2008
kww2008
dadofranz
  • Locked
  • Question
Can sap2000 design steel members for torsion??
Replies
0
Views
93
dadofranz
dadofranz

Part and Inventory Search

Sponsor

Back
Top Bottom