Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Threaded Holes in Variables Table

Thread starter Milkboy
Start date Jun 7, 2002

Status: Not open for further replies.

Jun 7, 2002

Milkboy

Mechanical

Im using a Excel spreadsheet to drive the variables table for components in SE part. This is working fine until we have to 'drive' a threaded hole from Excel.

In the variables table, the hole is shown as expected. Yet, when a threaded holes, rather than simple hole, is selected, the variable for that hole disappears.

How can we drive a variable for a threaded hole ???

TIA Milkboy