schlebb
Industrial
- Feb 17, 1999
- 18
Someone has suggested that the length of thread shown in Sect.VIII Div 1, UG34(q), must be as long as the calculated thickness of the end cap. This is based upon the sketch (q). My argument is that sketch 
shows a retaining ring with a thread length less than the thickness of the end cap. In addition, the text addresses the issue of thread strength separately from end cap thickness. Has anyone come across this issue before? If so, how have you calculated the required length of thread?
shows a retaining ring with a thread length less than the thickness of the end cap. In addition, the text addresses the issue of thread strength separately from end cap thickness. Has anyone come across this issue before? If so, how have you calculated the required length of thread?