May 6, 2011 #1 TD66 Mechanical May 6, 2011 2 I am learning Wildfire 3 sheetmetal and trying to figure out how to add a countersunk hole, any tips? Thanks.
I am learning Wildfire 3 sheetmetal and trying to figure out how to add a countersunk hole, any tips? Thanks.
May 6, 2011 #2 looslib Mechanical Jul 9, 2001 4,205 Use the hole wizard, just like for any other hole. "Wildfires are dangerous, hard to control, and economically catastrophic." Ben Loosli Upvote 0 Downvote
Use the hole wizard, just like for any other hole. "Wildfires are dangerous, hard to control, and economically catastrophic." Ben Loosli
May 6, 2011 Thread starter #3 TD66 Mechanical May 6, 2011 2 Thanks. The hole tool was not on the tool bar so I thought it wasn't there for sheetmetal, had to look under "Insert" command. Upvote 0 Downvote
Thanks. The hole tool was not on the tool bar so I thought it wasn't there for sheetmetal, had to look under "Insert" command.
