Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Shear Wall in Type II construction

Thread starter archtype
Start date Nov 14, 2002

Status: Not open for further replies.

Nov 14, 2002

archtype

Structural

I am an architectural designer and not a structural engineer. I have a large metal building warehouse with small attached areas that are 18 gauge steel stud construction with insulated metal panel cladding. Lateral forces require a shear wall application in a couple of these stud framed appendages. Cross bracing is not possible due to penetrations. It is essential that Type II construction (sprinklered) requirements be maintained so I am assuming I cannot use OSB sheathing. A looming deadline does not allow time for me to thoroughly research and educate myself to options. Any help?