Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Ring and Pinion Centerline

Thread starter builderofstuff
Start date Feb 28, 2003

Status: Not open for further replies.

Feb 28, 2003

builderofstuff

Mechanical

Hello All,
I am in need of a ring and pinion centerline dimensions drawing for a chevy 12 bolt rear end. I am making a right angle gearbox using this ring and pinion. I choose this gear because of off the shelf availability, reasonable price and proven track record. Any help would be appreciated.

Thanks
Tony Kutscher
Builderofstuff@aol.com

P.S. I can build it just can not draw it, so if there are any volunteers for this simple gearbox I'll take all the help I can get.