sams
Mechanical
- Mar 13, 2000
- 34
Good Morning Readers of the forum,
I have a pdf file which I open by using Acrobat.
Cut and clip the text and graphics to the clipboard.
Then I switch to Solidworks .slddrw file and from pull-down menu
I select “paste” and paste the data from clipboard on to my drawing.
This data, I paste in .slddrw file is very low resolution making the text
look very fuzzy on printed hard copy.
is there any switch somewhere that the reader would know, that can be set
to increase the resolution, making the .slddrw file look halfway legible?
Thanks and will appreciate the response.
I am using SW2006.
Sam
I have a pdf file which I open by using Acrobat.
Cut and clip the text and graphics to the clipboard.
Then I switch to Solidworks .slddrw file and from pull-down menu
I select “paste” and paste the data from clipboard on to my drawing.
This data, I paste in .slddrw file is very low resolution making the text
look very fuzzy on printed hard copy.
is there any switch somewhere that the reader would know, that can be set
to increase the resolution, making the .slddrw file look halfway legible?
Thanks and will appreciate the response.
I am using SW2006.
Sam
