Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Member Offset

Thread starter Bill2001
Start date Nov 8, 2008

Status: Not open for further replies.

Nov 8, 2008

Bill2001

Civil/Environmental

Hi,
Does anyone know When using MEMBER OFFSET command in STAAD the distance given is the distance from CG or shear centre?
What a bout open and unsymmetrical shapes where the CG and shear centre doesn't coinside?
Appreciate if someone could give an example.

Thanks