Mass on a drawing (NX1899 and onwards) 2

[Arkance/PhoeNX]

I made a video a few years back when NX1899 was released, showing how to put the mass on a drawing.
I've been meaning to update based on questions I had gotten and have finally done so.

I've updated the FAQ on Eng-Tips where this is listed:

https://www.eng-tips.com/faqs.cfm?fid=2086

Video was recorded using NX2206 (June 2022 release).
License used was a NX41000 NX Mach Advantage, so no Advanced Assemblies was available.

Examples are shown for the mass of a single piece part & for an assembly, with how to show the mass either in a note or in the titleblock.
Methodology is the same for both, just the update process changes, depending on note or titleblock.
If you have an Advanced Assemblies license, then you can update using the Update Mass Properties button.


Anthony Galante
Senior Support Engineer


NX9 to NX2008 (11 versions)

 

[jerry1423]

Thank you very much.


Jerry J.
UGV5-NX1899

 

[cowski]

Good stuff. Thanks!