Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

How to insert bend table in ST?

Thread starter bheim
Start date Feb 28, 2011

Status: Not open for further replies.

Feb 28, 2011

bheim

Mechanical

Hi,
I'm trying to insert a bend table into all my drafts for pipes I've made using XpresRoute. However I can't seem to insert the any bend tables for the pipes. I've also tried with some sheet metal parts just to see if it would work for those, but again, nothing. Has anybody encountered this problem before?
Thank you