Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

FEA Modelling of Automotive Hb

Thread starter wildboar
Start date Jan 24, 2004

Status: Not open for further replies.

Jan 24, 2004

wildboar

Automotive

I have a meshed model of a vehicle wheel hub and i am thinking of applying vehicle loads via an RBE3 spider from axel centre to the bearing contact surface on the hub.I have linear beam elements going from the RBE3 to the Tire Contact Patch position.
Any thoughts on where to best restrain the model.I am thinking of restraining the model at the wheel bolt hole positions.
Any opinions on this?