Design Table & Threads

[xgrigorix]

I have a component which has a 1/4-20 UNC-2B thread running through it. I would like to set up a design table to drive multiple configurations. I cannot for the life of me get the table to drive the thread, too. Everything else comes in fine. Is this even possible?

SW2006 SP5.1

 

[SBaugh]

As far as I know you can't control that in a Design table. You could control the Dimensions.

Regards,

Scott Baugh, CSWP

http://www.scottjbaugh.com

faq731-376

 

[xgrigorix]

I decided to create all of the different sized threads & use the design table to suppress & unsuppress as needed.