Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Combined Shear & Tension in Bearing-Type Connections

Status
Not open for further replies.
jwall

jwall

Structural
Jan 5, 2003
4
Can the formulas from Table J3.5 LRFD Vol. 1 be used for ASTM A153, Grade B5 (Fu=100ksi, FY=80ksi) and Grade B7 (Fu=125ksi, Fy=105ksi) ?

In other words can you use the Tension Stress Limit equations:

Thds. incl. in shear plane: 0.98Fu-1.9fv <= 0.75Fu
Thds. Excl. from shear plane: 0.98Fu-1.5fv <= 0.75Fu

Are these formulas valid for this grade steel or better yet any grade steel ?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
The ASTM Standard should be A 193 instead of A 153.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

StructuralAddict
  • Locked
  • Question
Maximum Bearing Length
Replies
7
Views
1K
KootK
KootK
Wanna_be_SE
  • Locked
  • Question
AISC_PJP Welds in Tension (?)
Replies
7
Views
4K
Wanna_be_SE
Wanna_be_SE
ELSARWAN
  • Locked
  • Question
how can i calculate the required torque for the pre-tension joints 6
Replies
3
Views
1K
dik
dik
TTomaz
  • Locked
  • Question
Steel &quot;Unheaded&quot; Stud Anchors in Composite Components 1
Replies
7
Views
940
WesternJeb
WesternJeb
Wanna_be_SE
  • Locked
  • Question
Prying in AISC 1
Replies
3
Views
2K
PersonalProfile
PersonalProfile

Part and Inventory Search

Sponsor

Back
Top Bottom