Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

camed surface on a cylinder?

Status
Not open for further replies.
ozzkoz

ozzkoz

Mechanical
Aug 13, 2009
51
I am tying to create a camed surface cut into the ID of a cylinder. Does anyone have a good method for this? Essentially I want a groove around which has a ramp up to another level.
 
Status
Not open for further replies.

Similar threads

shanemolloy
  • Locked
  • Question
Replacing a component in an assembly based on excel
Replies
0
Views
296
shanemolloy
shanemolloy
S MORIN
  • Locked
  • Question
ptc_material_description in a note
Replies
0
Views
1K
S MORIN
S MORIN
whatev-nvm
  • Locked
  • Question
OBJ of a simp rep of an assembly gets exported with incorrect coordinate system
Replies
0
Views
1K
whatev-nvm
whatev-nvm
dkakth
  • Locked
  • Question
dependency on import ? 1
Replies
1
Views
327
3DDave
3DDave
freerangequark
  • Locked
  • Question
Control of a dimension or parameter in simplified rep?
Replies
1
Views
1K
3DDave
3DDave

Part and Inventory Search

Sponsor

Back
Top Bottom