Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

AS Fusing Requirements

Thread starter audios
Start date Oct 1, 2002

Status: Not open for further replies.

Oct 1, 2002

audios

Electrical

I'm located in the U.S. & am designing a control system to AS requirements. Incoming voltage is 690 VAC, 50 Hz. Per spec. HRC fuses are required. I need a fusible disconnect switch & fuses for the power section. Can anyone recommend a suitable switch & fuse mfr.? Fuses will also be required for the VFD & step-down transformer primary. Also while I'm at it, can anyone tell me where to find a 690/120 transformer, around 375 VA? Mfr. & P/N's would be appreciated. Thanks very much for your help.