Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

3D Induction bends

Thread starter Harshu03
Start date Apr 22, 2021

Status: Not open for further replies.

Apr 22, 2021

Harshu03

Materials

Are the test bends to qualify MPS as per ISO15590-1 produced at the same angle that of production bends..

We have a problem of 3D bend produced out of tolerance of mentioned bend angle per requirement however the test bends for MPS were tested at different angles that of production bends.