Does anyone have a very reliable way for checking that holes have been fully threaded and to a proper depth.
This application would require a very short cycle time to check the hole. The holes to be checked are M6.
Could this be done with the use of an air check probe and sensing for depth with...
Can any-one tell me where I can find facilities to test the strengths and characteristics of projection welds in the Southwestern Ontario area?
These places will have to be able to certify the weld test.
Destructive or non destructive is fine.
Thank you
I hope I have the correct area.
Can anyone help me with calculating the SCFM for a welding fume hood.
I need to calculate the size of piping for the top of the hood and any other information that will be required.
Thank you
Wraith
I hope I'm in the correct forum,
Can anyone tell me where I might find information about the flow dilling process.
Information about suppliers for components and general process information would be great as well.
Thank you
Wraith
I am looking for a site that will help me find the specifications for different materials like MS-264-080 XK
as far as I can see this is a HSLA 080 material.
Can any-one give me some advice as to where I might look for such a site.
Thank you
Wraith
I have looked back throught the testing proceedure and all the steps involved are the same in the machine as in the test rig.
The only difference is that the pressure for the bladders could have been changed by some one in the machine with out anyone knowing. (Seems to be Very Likely)
As to the...
I have this application were I require a sleave over an inflatable device. The device is a Firestone Air picker.
This device inflates from a cylinder shape to a balloon shape.
The application I am using this device for is to pick up engine pistons from the sides by inflating the bladders one on...
I am curently looking for a new 11 x 17 B/W printer for our design department. We are presently using a Canon BJ 230 B/W that we have had for years and it is starting to slowly give up the ghost.
All of the printers on the market are colour and print between 4 to 12 pages per minute. We have a...
I purcahsed a designjet 500ps and every time I sent a print to the plotter MDT 5 would give me an error, and then crash.
I changed the plotter driver to a 650C plotter driver and I have no problems printing.
I found the driver on the MDT5 Program disk.
This might solve your problem.
I hope this...
