Search results for query: *

Check your sketch. I created a sketch with 3 circles (2 identical) and extruded the feature curves. I got 2 solids from one extrude. Maybe the sheet body comes from an almost complete full arc.

You would need to recreate the Pattern Geometry but with associativity turned off.

Zip attached.

No need to enlarge the bounded planes, Face Blend will span the gaps:

You can break the section curves down to 2 curves instead of one, i.e. 2 arcs instead of a circle.

It doesn't happen on exiting the dialogue box, but it seems like the measurement function does lock up my computer for a minute or so maybe 10% of the time. Haven't really noticed any other hang ups. NX1953.

I will cling to the old sketcher as long as possible, then probably retire. I've been a NX fanboy for decades, not so much with the new sketcher.

Looks like it works.

In the camber line equation in pic #3, what do p, t, m, and c represent?

Actually, Isoparametric does work, I just forgot to set it for U and V.

I used the edges to create a ruled sheet body but isoparametric curves didn't work. Instead, I used Offset in Face to offset one edge of the ruled body half the face width, then created a tube that essentially matches your original. Part file also attached.

I downloaded a STEP file of a spring and used the ruled surface/isoparametric curve approach to recreate the centerline. I used the isoparametric curve to recreate the tube and it seems to work. I tried to create a Tube Centerline using both faces of the tube but it failed. Tube Centerline does...

Tried to open the file but found no geometry. 2.2KB is pretty small for a STEP file.

Does the edge that runs lengthwise on the tube have a diametrically opposed counterpart? If it does, it might be worth a shot to create a ruled surface between them then create an isoparametric curve on that surface to determine the centerline.

You could try Synchronous Modeling "Offset Region" and select all the faces except the blends into the main body.

Another version.https://files.engineering.com/getfile.aspx?folder=7fe4612e-f5d6-45bf-84f8-200808c2f889&file=wire_panel_2.prt

Sounded interesting so I built this. You can use length and width to make an oversize panel and trim to size.https://files.engineering.com/getfile.aspx?folder=e4a7a12d-f0f4-4a2d-acec-967c80132282&file=wire_panel_1.prt

I need to maintain contact between the two blue surfaces and the yellow surface as the green component is rotated/translated. I've tried multiple combinations of touch/align/angle but it always ends up either being outright over-constrained or prevents dynamic movement. I would like the...

I usually change the dimensionality to "Unitless" when whenever I am using equations. This prevents mixing angles with lengths and length x length turning into areas.

I started having trouble with my right hand years ago until I discovered Contour mouse. Back then it was available in several sizes to fit your hand and in left/right versions. Mine is cartoonishly large but fits my hand without needing to grip too hard. It's a true three button mouse so I...