Hi everyone,
I have a complex building which has a few grid systems, to make the question simple we say one globle grid system and one 45 degree grid system (system 2), I know I can switch between the two systems and the coordinate of points shown are consistent with each grid system. But when I...
Hi everyone,
In Safe version 12, can we show slab design reinforcement (strip based) together with our defined strip and width? I found even if I already set display options as strip layer and strip width on, when I go to DISPLAY- SHOW SLAB DESIGN, the strip can not be shown on the page. That is...
Hi everyone,
I am pretty new in etabs and in steel structure design, but I tried several times using etabs doing analysis and design of simple supported steel beam, I usually use auto selection list letting the program decide the proper section for the member, it worked before. I am trying to...
Hi everybody,
I'm new user of Etabs, I built a triangle steel truss model using Etabs, top chord and bottom chord were modeled as continuous member, inside webs are pinned to top and bottom chord, the calculated internal forces seem to be right, but in member design, the program consider the...
