Hello,
Very stuck with this issue and curious what to do. It has to be something simple.
I've used these pumps (Ingersoll Rand Flowserve SMP-1000 centrifugal) before, 4 times, in a similar application with great success. Now I've installed 5 units where the seal begins to leak within 5...
Hey,
Just curious if anyone had run across Table 6 in B17.1 says the width tolerance of square keyways/keyseat for 0.25-0.75" wide was +0 -.002/ 0.75-1.25" wide was +0 -.003". Therefor the keys would be shrunk. There is no direction as to what class of Key is required,Class 1 or 2 on a motor...
Hey,
Just curious if anyone had run across Table 6 in B17.1 says the width tolerance of square keyways/keyseat for 0.25-0.75" wide was +0 -.002/ 0.75-1.25" wide was +0 -.003". Therefor the keys would be shrunk. There is no direction as to what class of Key is required,Class 1 or 2 on a motor...
Hello,
I've been looking for a replacement gearbox unit for 12+ months with no luck. Cannot believe this style of gearbox isn't sitting on the shelf somewhere.
The output shaft have to be 90 degrees apart. 480 ft-lb / 651 Nm torque capacity required 80-130 rpm operation
Our old gearbox is...
Hi All,
I've got a fairly unique issue with respect to process water taken directly from a river close to a Glacier and being filtered down to 75 micron.
The water is fairly silty with glacial till, talcum powder like fines. Algae is also present in the water stream. The fine size particles...
Hi All,
Looking though some old calculations for valve sizing and performance for Jet Flow Valve orifice.
There's a formula relating both Coefficient of Discharge Cd and K without taking the Beta factor into account
K=Cd^-2 example...
